Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello everyone, who used friendlyarm of nanopim3 it? This is a very new board, with a Samsung 6818 chip, can run Android, debia and ubuntu core systems. This is a cost-effective pricey board, performance is also good, I run debian system when connected to the hdmi, but no screen output, do not...
Because the project needs a high bandwidth, the use of network card binding method. Network card eth0 and eth2 connected to the exchange chip 2.5G port, the other port system, the rate of 1G;
Eth0 and eth2 the actual test up to 1.2G, the need to achieve through the network card binding 1.6G...
Do you have any board recommended to learn it? I am a novice, before a friend recommended me to use friendlyarm development board, would like to see if there are other board suitable for learning it? :-D
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
