Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The nc6000 and that range of laptops suffer from the maxim chip getting hr joints on them i suggest removing board turning upside down and by the heatsink of the cpu is the maxim chip. Reflow or resolder the pins very small soldering iron required as pins minute! 1mm iron required to resolder...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
