Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, SunnySkyguy, thank you for your suggestion, I think that's a good idea.
One thing I'd like to make sure is that if I use schmitt trigger, the most regular structure, since my vdd is ramping from 0V to 3.6V, then the input for the Schmitt Trigger should be a division of the vdd which follows...
No, 2.7V this threshold is for vdd ramps from 0V to 3.6V. 2.7V is 3/4 of 3.6V. I wanna make sure for each case threshold voltage beyond 3/4 of the vdd.
If I sizing the transistor to make this vdd 3.6V case work, then for the case vdd ramps from 0 to 3.5V, right now the threshold required is 3/4...
I was asked to design a Power on Reset circuit to be able to work for supply vdd range from 1.6V~3.6V in 28nm process. I need a transistor level structure for this design.
This power on reset only has one input which is supply vdd and it's a ramping Vdd.
Take Vdd ramps from 0 V to 3.6V as...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
