Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello. I would like to interface an Atmega8 with a stepper motor. The motor is a little bit strong and it requires about 2.2 Amps. I burnt a L298 trying to control the motor, and someone told me i should link two L298 in parallel. I made the next schematic, is it good? (the diodes are 1N5822)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
