Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
Me too i'm looking for a dsp development board...
first, I was thinking of a TI dsp (TMS320F2812)
But I just want to know why that you say that Analog Devices DSP are better??
thanks
luigi
Hi,
I have done a bootloader for PIC18 uC, and I would like to know if it is possible to program Config files by software (programmed by my bootloader.) ???
thanks for your reply ...
Luigi
Re: PIC18F4431 problem ....
thank you guys, it's now working fine....
I haved tried to put some caps closely to my device and reprogram it, and now it seem to work perfectly!!! 8O
regards ...
:o
Luigi
by the way,
I am using the Picall programmer latest version ( www.picallw.com ) and I have modified the device.ini fill, so it can accept PIC18F4431, but all of this works fine, because, when I read the device, my code is all ok ....
anyone has an idea of what I am doing wrong??
Re: PIC18F4431 problem ....
hi, here is my code with the configs...
I am using C18 code and my configs are set as High speed chrystal, but I have tried with the internal oscillator, and it doesn't work anyway!!
my full part number is the following: PIC18F4431-I/P
#include <p18f4431.h>...
pic18f4431
hi, i'm beginning to use the PIC18F4431 (i have used PIC18F458 before) and I don't succed even to make work this pic!!!
I have a simple code that simply outputs data on the ports, and absolutely nothing is output on the pic???
What could be my problem??
I think my Configs are...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
