Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I would like to identify the type of resistor in the photo on the left.
After removing the paint, I can see a dark/graphite cylinder with a short "bar" (gouge/cut). Would this be a carbon resistor? Unfortunately I wasn't able to cut/split it with pliers to check the inside.
Thank you...
So, I connect DC generator to the input (Vin) and oscilloscope to the output (Fout) of this circuit.
If I set Vin to 1V - I get nothing on output (Fout).
If I set Vin to 2V - I need to wait few minutes until input voltages will be at the same level and then I can see output signal (Fout)...
Hello!
I'm trying to simulate circuit as below and it just doesn't work as described. This circuit should convert voltage (0-10 V) to frequency (0-10 kHz), so 1 V per 1 kHz. Maybe there is something wrong with this circuit?
I found this circuit on this website and also there is full...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
