Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
db to mv converter
jallem's formulas are right.Of course ,ypu can calculate more easily.First, you need computate the power with the voltage,Vrms(V)]^2/R. Attention here ,the impedance 's value is 50 Ω or the charateristic impedance of your system. Then you can convert the power from Watt to...
Re: Selection of inductor
I think you'd better use air.For you can adjust the inductance quantity in the filter real-time.It's very helpful when you are tuning it.And you can get a inducot more easily and quickly.The frequency is not a problem.In the high-frequency filter(usually several...
I think you may use a capacitor.What you want to do is to delay the output signal of the sensor.Add a parallel capacitor in the path between the sensor and the MCU.
Because th e capacior will slow the rise speed of the signal ,perhaps it will do.
I am designing a switch with PIN diode .I want to know the insertion loss before simulation.But I can't find a fomula to impelet it ?Who can help ?Please!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
