Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Err... now i tried with different setting and it seems working. this picture is when i import, i uncheck the (line geometry). now i tried to import as 2D and set the measurement unit to 0.05mili. tomorrow i will tried again and hopefully it work!
dear plasma, the link you show me is a good 1. but, my main concern now is how i wanna pick all the faces without left-over some faces in dark shadow? after i obtain a correct pick face then only i can start bending.
to anyone that know CST EDA tool on bending technique...
i'm stuck in the bending of flex. previously when i import my flex file, i cannot bend certain layer till to the error "simplify or heal the geometry". but, now i solved it by untick the geometry line when i import my ODB++ file, and...
i'm stuck in the bending of flex. previously when i import my flex file, i cannot bend certain layer till to the error "simplify or heal the geometry". but, now i solved it by untick the geometry line when i import my ODB++ file, and another problem that should not be problem occur. attached is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
