Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
How can I calculate the inductance and capacitance of a single-phase half-controlled bridge rectifier? Given: input voltage (RMS), input voltage frequency, load resistance, firing angle of thyristors, and maximum ripple of output voltage and current.
OK, I added that voltage drop but it has pretty much no impact on the results, due to the way my model is created. Commutation is implemented as changes between equations, there are no changes of diode resistance.
Hi,
I am trying to create a simulation of a power stage of a boost converter in ModelSim to further create a PID controller on FPGA. I have written differential equations that describe a boost converter and created a testbench for simulation. Unfortunately output signals (inductor current and...
Part of transmission channel is hardware connecton through GPIO. My system reports that CRC is not valid if, for example, one pin of this connection is missing.
Hi,
I am making a project using DE - 10 Standard kit. In this project, data is sent from one M10K block to another through a DDIO receiver/ transmitter. I want to do a CRC checker to check if the transferred data is valid. I have a question: how can I insert some errors in the transfer? I heard...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
