Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Ok and can you pls tell me how can I find out the impedance of this full wave loop or even change it to cca 300 ohms?
---------- Post added at 17:54 ---------- Previous post was at 17:50 ----------
And perhaps how the impedance, or other parameters would change if I would use for example a...
Well magnetic dipole should be a current loop I hope I did that right. Or is it only a loop antenna. Then I dont know what is the difference between these two. I will connect this magnetic dipole to a magnetron through coaxial cable and using a balun. And this magnetic dipole will hopefully...
Hi, I want to design a magnetic dipole to use for frequency 2,45 GHz. My results are
Wavelength: λ=300 / 2450 MHz = 0.122 m
Diameter of the loop:
0,122 m/ 3,14 =0,0388 m =3,885 cm. Now I'd need to know the impedance of this antenna, but cant find out how to calculate it. The ideal impedance...
Antenna
Hi in CST I want to simulate 2 antennas , the first one is to transmit and the other one to receive . When I run the simulation in CST it excites both antennas separately but I need to do this only for the first one and want to see the energy received by the other one.
CSTferrite
Hi Im new in cst studio and want to simulate a ferrite loaded antenna but I cannot find the ferrite material. I dont know what material Ihave to choose from the offer in the window "load from material library".
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
