Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey Shameemkabir, thanks for spending the time to view my project.
For my design, my objective is just to evaluate the difference between 1 source and 2 sources being place side by side. I wanted to see if the emission will be doubled as expected. But right now, for the 2-sources case, the...
May I ask what should the amplitude & phase shift be?
I tried entering all 1s for amplitude and all 0s for the phase shift for both ports, but it shows error for combining the results.
Btw, my source is just a simple circuit with a port connecting to a 50ohm load. I've two similar sources...
My DUT is a simple box with two sources inside, parallel to each other. When I run transient analysis with CST MWS, it shows individual results of each source.
What should I do so that the transient analysis calculates the two sources as one source as a whole?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.