Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I think I have the information I need now. I just need to program the CPLD using the USB BLASTER and needed to identify the pins, so that I know where to wire the jtag connector. There's no pin header on the pcb, but I found 6 pads that I thought could be used, but i didn't know how to check...
Thanks for your reply. I looked earlier but I didn't find anything. Thanks to your link though, I think I worked it out.
For 5M240ZT100C5N it should be pins 22 to 25.
I've been trying to find the pinout of the Altera Max V so that I identify the jtag pins. I want to program the IC using a jtag header and USB BLASTER but I have so far drawn a blank. Can anybody help me out?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
