Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: uart and parallel lcd
The command 0xFF 0x00 0x00 0xFE in serial mode is "Display On", in the same maner, for example 0xFF 0x00 0x00 0xFE is for "Display Off"
I think these commands can be used to turn off and on LCD to maximize battery use
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
