Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
But the problem is that the first segment(45 outer bend) has an input but no output but in second segment(90 bend), one is
connected to ground layer (shorted), the other is the output of the whole coupling process.
by the way the operating frequency is 2.45Ghz.
Does this gives any clue about...
The coupled microstrip line is following a 2.45Ghz oscillation circuit (Colpitts circuit).
So,the coupled microstrip lines are used to couple a small amount of energy from the oscillator...
Do the previously mentioned shapes related to this purpose?
thank you
Hi,
Asking about coupled microstrip lines assuming where two conductors are made in the upper layer...
Does these two conductors need to have the same shape?
Will it work if i made the first L-shape and the second L-shape with 45 bend?if so,what are the things i need to take it under account...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
