Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks a lot Fvm and keith ... its my first board and I had 45 degree's everywhere but I kept moving things around to shrink the board and I dont mind the looks of the board as long as it works... and I agree the board can be done without blind vias I tried initially but there were few deadlocks...
Or you can click the properties of the object , it has the angle which normally is 0 you can change it to any angle you want. but the command line interface is much faster and better.
I Have used EAGLE CADSOFT to layout this board and I think I'm almost done with it , But I'm not sure if my design rules are proper or not. so i have attached my *.brd and also drc rules. I have used multiple polygons for power planes in the same plane , so its not a standard power plane...
I'm designing a 6 layer board and for some reason I have multiple power planes on the same layer and also AGND and DGND on the same plane. Now if I try to change the layer 2 which has AGND and DGND as a supply layer , it wont allow me to do it !! If I leave it like this would it be a problem ? I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
