Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by Biswajit.dakua1

  1. B

    GSM module does not work.

    thanks for reply. I uninstall the hyperterminal and install it again and also used putty.what the terminal setting should be? I don't know actually what "detect carrier loss" do. No,i use RS 232 cable which has the setting of COM port in both terminal. I am using serial cable only,not serial...
  2. B

    GSM module does not work.

    I uninstall the hyperterminal and install it again and also used putty. So what the terminal setting should be? I don't know actually "detect carrier loss" do. No,i use RS 232 cable which has the setting of COM port in both ways. - - - updated - - - I am using serial cable only,not serial to...
  3. B

    GSM module does not work.

    Thanks for reply.I uninstall the com port & also connect the module in another PC . But the result is same.
  4. B

    GSM module does not work.

    I connected the GSM module with desktop through UART. It was working fine while i using hyperterminal.But after some time it didn't reply on any AT command.After writing the command, if i pressed ENTER , the pointer would go back to first position. I have checked the box "detect carrier loss"...
  5. B

    Interfacing FPGA with GSM module

    I understand your first process. Can u explain me about alternative process .
  6. B

    Interfacing FPGA with GSM module

    I have to send a message to my mobile phone using FPGA.So I am trying to interface GSM module with FPGA (DE 1) board.But i don't know how to write AT command in verilog code.Can anyone help me? Thanks in advance Biswajit
  7. B

    [Moved] Taking input by expansion header in de1 board

    Hello In my project i have to take input through expansion header. When i use push switches of de1 board it gives me desired output . But when i use expansion header pin (gpio_1 unify with gnd pin in jp1) it does not work . Do i have to make change in program or anything to change in pin...
  8. B

    Tuned base oscillator

    Thanks for your hard work...
  9. B

    Tuned base oscillator

    Hello I am new in electronics.Please someone tell me how a tuned common base oscillator work. If you added a appropriate circuit diagram , it will my pleasure. Thanks in advance
See more

Part and Inventory Search

Back
Top