Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes I tested my oscillator and it works. I connected it properly and for clock signal I connected to resistor of 200Ohm and from that to LED and it lighten up very fine, so oscillator works. I think the chip is dead, because when I did fuse bits reprogramming it asked me some question that do...
I just want to make sure that is this external clock source **broken link removed**, I use that particualr oscillator for XTAL1. Is it proper part or no?
I can't even reprogram it because I get "initialization failed rc=-1" error. This chip must be somehow erased and there's a way. Does AVR burn-o-mat front end supports atmega328P?
Hi,
I'm new to this forum but I have been following it for a while and received good advices :). Now I need help, since I think I messed up fuse bits :D. So here's my problem:
I have ATMEGA328-PU microcontroller and I use WinAVR and AVRDude to change fuse bits. Before I did fuse bits change...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
