Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello, I haven't encountered such thing before - Allegro does not want to read the footprint files! The situation is like this: I have created a folder Layout on my desktop and indise I have placed folder Devices and another one Symbols. Without any change in the library paths the BRD files that...
Hi again,
please take a look at this post, I have explained some basics of the guy there and uploaded pictures also. If you have further questions let me know :)
Hello majnoon,
Where in User Preferences? at the Logic section I selected Capture as Logic tool, but I can't figure out what other options I should select or change. As for now no luck with PCB to Capture selection :(
Hello,
there is probably a better way for doing it, but what I do is back annotate the design first, then in Capture change the footprint type, generate new netlist and import it in Allegro PCB Editor. That way I change the footprint of some components if nessesary during the PCB Design process...
Allegro PCB SI
Hello,
I am newbie in Allegro but here are the things that will get you going:
Get this boook : https://www.amazon.com/Complete-Design-Using-Capture-Editor/dp/0750689714
There it is very well explained how to start with generating netlist, importing logic, etc.
Now, in order for...
Hello everyone,
I use Allegro SPB 16.2 and when I have open schematic in Capture and PCB in Allegro PCB Designer, when I click on component in Capture it lights up in PCB Designer and zooms the screen so that only the selected component is visible in PCB. How Can I adjust it that it does not...
Hello Gurus,
I am newbie in Allegro and slowly make my way ahead. I just finished my first PCB made with Allegro and everything looks fine when I review the Gerbers with GC Preview, except the fact that I cannot see any board outline there. Is this normal? I guess not...Please help me to fix...
Hello,
I am creating my first PCB with Allegro PCB Designer and I was suprised to find out that the footprints provided by Cadence are missing soldermask and pastemask layers. Instead of Editing them I started creating every single components from scratch, this way I would eliminate some bad...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
