Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I am using IC5.0.33 in Fedora Core 4. The Cadence runs fine except for the following things:
1. When I open a schematic and try to check the properties of transistor or
resistor or any other component then the parameters like the lengt, width,
multiplier etc. do not...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
