Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: how to build a one shot where trigger period > RC time constant?
Thanks for your answer, I've missed this part.
4uA in standby is not that bad, worse is 160uA when active because in this application it will be in that state very often.
In the datasheet for the 4047B they did not...
Hi all
I know this component might be considered as digital but "embedded systems and real time OS" didn't feel like the right category to create the thread in either... sry if I placed it incorrectly..
Why I need a multivibrator:
I'm working on a project where two sensors is going to trigger...
thanks for your answer!
I now understand 2.
But I don't really understand 1. Cannot the window comparator itself be considered as a kind of hysterisis where the "dead window" is the hysteris?
It cannot be that the positive and negative response (output signal) of the sensor is unbalanced...
Hi!
I'm new to electronics and are about to use the Murata's IRS-B210ST01 PIR pyroelectric sensor. Provided to the sensor is schematics of typical application circuit for human detection:
**broken link removed**
or
Shortly the circuit is a filter/decoupling, a load resistor, a non-inverting...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
