Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I built a antenna for a WPT circuit I would like to measure the inductance and the resistence with a Semiconductor Device Analyzer B1500A Agilent. I'm trying to set the C-V Sweep test but I'm in doubt about what kind of connection I need to do. I have the Agilent N1300A Cable and the B1500A A5F...
Hi, I am testing a WPT circuit.
The input sinusoidal signal of the primary coil is from the function generator with Vrms=7,9V and frequency 130KHz.
I am using inductive coupling method with a cap in parallel with the Tx and Rx coils.
When I have the distance between two coils lower than 2cm...
I'm a undergraduated electrical engineering student and I was reading the antennas chapter in the RFID Hand Book(Klaus Finkenzeller) and it provides equation L=N²µ0Rln(2R/D) to calculate the inductance of a conductor loop that is used as an antenna. But the book also says that I must respect the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.