Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey @dpaul
Yes, I tried doing this. As temperature hits the upper limit of shutdown the board shuts down, but after the board cools down it doesn't boot up by itself.
But when I cold/warm reboot the entire system, without having to flash the board with a fresh image it boots up and runs as if...
Hey dpaul,
In the IP Core documentation they have mentioned contradicting statements as far as I see.
"when the die temperature exceeds the OT upper threshold (or the default of 125°C), the OT alarm logic output becomes active and 10ms later the device initiates a shutdown sequence. When the...
Hey all,
I have setup a design in the xczu19eg FPGA which contains PCIe, QSFP and some DMA.
To implement Over temperature protection, I have used the System Management Wizard IP to enable OT and have configured the same for trigger and reset (Hysteresis mode).
When the board reaches the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
