Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
it probably has to do with the simulator which has as you state an "ideal" voltage source which implies that for any current drawn there will be no voltage drop. This would not be the case for a PV panel as when current is drawn the voltage drops and the feedback circuit will take this into...
Hi Oscar,
Late reply but to clarify for other readers what this module is for. The inverter is to povide 380vdc after rectification for conversion to 50hz ac sinewave with modules like EGS002.
Well at least that is what my supplier reckons.
I have used this module in 2 scenarios, 1 as low power...
When I put in more than 1 opamp the power pins are connected and in most cases that is fine. In my current circuit I am implementing a linear optocoupler (HCNR200) to isolate HV from LV circuits and I want the opamps on different supplies.
I cant find a way to disconnect the power pins. It is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
