Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If you wanted to use this exact product, just substitute the LM 317 for a LM338T. If you wanted to just use this design on another board, it wouldn't be that hard to reverse engineer a schematic from this link you provided. Alternatively, you could start by searching for a regulator that meets...
Re: REQ:24 VDC to 12 VDC
Uh.. perhaps you mistyped your question since this seems pretty easy and since you're a supermod, I'll assume you know some stuff..... but for a DC to DC conversion of 1/2, use a simple voltage divider of two resistors. Make sure they are rated for the current you will...
I agree with HERO. You should paste, place, and reflow the component. Of you must use a single sided board, create a mask for your TSOP and other fine pitched parts and then send it through the wave.
how to connect idsel to pci card
Concerning the book.. Mindshare, Inc summarizes the PCI spec nicely in their PCI Architecture book. Not sure if it's in eBook though.
Cheers.
Re: PCI signal length...
You can extend it, depending on how long the traces are on the PWB. You're most likely experiencing signal integrity issues due to 'wiring' it. It's generally not a good idea to do that.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
