Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Many thanks for your answer. I put a 1KΩ resistor in series with the IC . Now, the FPGA pin is not destroyed, and the output signal amplitude of the IC is equal to power supply, but the problem is that we do not see any pulse. The series resistor keeps the FPGA pins safe, but no pulses are...
Hello dear all,
I have run into a problem regarding the FPGA. The FPGA output signal amplitude is 3.3, and to drive my switches, I need to increase the voltage up to 15 V. I am using TC4427(dual power mosfet driver)as a buffer after FPGA , and would like to check the possibility of my gate...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
