Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello all,
thanks for ur reply,
PlanarMetamaterials please,how can i define the integration line manually?
flanello i tried several times to change the frequency range and make it larger but it gives me error on the simulation((the calculation seems to be unstable!))
- - - Updated - - -
the port size is 6 times as wide as the width of the microstrip line(1.9) and 5 times as high as height of the substrate(0.813),but when i use this height i got positive S11 in both side,and when i change it i get different result like the one i sent it to u before .
hi PlanarMetamaterials ,
thanks for ur help, actually i changed the dimensions of the port and i reduced it's height, but S11 became like in the pic below!!
i think it's much better but still there are frequencies have a positive value,
wt's ur suggestions??
regards
Hello all,
actually i am facing the same problem but with CST,the both side of S11 more than 0dB.
Is there anybody could help me please about this matter ?
i attached an image show the problem.
Appreciated
Hi all,
Actually i have designed a multilayer rectangular antenna using CST,but i face a problem in the simulation which S11 in the simulation always appear more than 0 dB, i have tried to change many parameters but the problem still.i don't know wt's the problem!!
Could anybody help me to...
Hi all,
Actually i have designed a multilayer rectangular antenna,but i face a problem in the simulation which S11 in the simulation always appear more than 0 dB, i have tried to change many parameters but the problem still.i don't know wt's the problem!!
Could anybody help me to find a...
Hi,
i constructed a multilayer rectangular DRA, but unfortunately after the simulations i got 3 errors:
1.(The first mode at inhomogeneous port 1 is hybird.this could lead to an inaccurate energy balance.please check ur structure)
2.(24 mesh cells are represented in staircase mode and have been...
Hello guys. I need some help regarding the setting of microstrip line precisely about the impedance calculation.
For microstrip line the impedance changes with strip width, substrate and height of the substrate.the width of the microstrip is calculated using a tool known as impedance...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.