Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: sim300 cant send ctrlZ ..its showing -> when im sending 26 =ctrl+z=0x1a;pic16f877
Thanks very Much kvii7. I got that working. There was silly mistake ..not disabled the receiver and was trying to send data. I should have disabled Rx first before sending data and also used straight cable...
I am facing the same problem man...I could not receive ok fro PIC16F877A. baudrate:9600; OSC:11.0592; SBRG: 71? if you found solution please help me..It has been a week I am trying to correct this issue. Thanks for your time
Re: sim300 cant send ctrlZ ..its showing -> when im sending 26 =ctrl+z=0x1a;pic16f877
I did check for ok . The problem now is its giving ok when i connect to hyper terminal but when i connect to pic controller its not giving the ok....could you pls take a look at code...it will be really...
Re: sim300 cant send ctrlZ ..its showing -> when im sending 26 =ctrl+z=0x1a;pic16f877
Thanks for prompt response. Any other solution without installing that. did you find any logical problem.
target16f877a, compiler hitech c ...couldnt send ctrlz to send sms it giving arrow mark when i send ox1a...please help sort this out thanks for your time guys
#include<htc.h>
#ifndef _XTAL_FREQ
#define _XTAL_FREQ 11059200
#endif
void tx(unsigned char);
void stx(unsigned const char*);
void...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
