Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
Yes, Cadence can directly read Ibis files. However, depending of the features of the Ibis file, you might be to translate it into the proper format prior to use in your particular simulation engine in Cadence. For instance, if your Ibis file pertains to a line-receiver buffer, the...
Hello,
There are actually parameters in IBIS to model the load capacitance. One parameter under which such effect can be captured is 'Cdiff'. This parameter is almost synonymous to C_comp which refers to the overall capacitance of the buffer. The Cdiff however gives capacitance found across...
Hello,
If you have the IBIS model available, then you're about half-way there. Most CAD tool (i.e. even the cheap ones) can read Ibis files. I would suggest setting it in in a testbench using a randon bit stream of data. This will allow you to look at the eye-diagram of the model (for the...
Hello,
If your Ibis file already has the RLC parameters correctly defined under the [Package] section of your model, you wouldn't have to re-defined in HSpice to avoid duplicating the parameters. HSpice would be able to read your file and extract the parameters.
Regards,
Hello shreyaskm,
The way you're defining the serie_resistance below appears fine. I'm not sure why Cadence is not detecting it. I would suggest placing a physical 100ohm resistor across your circuit in place of your model and see what you get. At the very least, this will confirm that the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
