Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
wow, that's a nice little tool. :-)
I have what I'm sure is a stupid question, but what sort of value should I be putting in the Fmin? Seems like the values that change are the caps and inductor when I adjust that value. I assume that stands for "minimum frequency". I put in about 10 kHz...
Thanks, the datasheet I originally looked at didn't have nearly as much info as the one I just looked at.
Anyways, so if I'm doing this right (modifying slightly the example step-up diagram where it goes from 12V to 28V), I'll just want to use that same schematic, but change the following...
I'm kind of a EE newb and am trying to use an MC34063AP1 to boost 3.7 Volts to 5 volts even and after studying the datasheet am a little confused on how I actually do that for the values I want?
For reference for what this will be used for, I found a bulk seller that was selling a lots of 10...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
