Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have two 12V 2Ah Led Acid Battery's YUASA NP2-12
These are serially wired to give 24V 2Ah
I am looking for a suitable charger or a schematic for such a charger.
Any ideas guys?
Hi Srizbf, thank you for your guidance,
Yes a breadboard is a great idea, especially for working on the delay period. Still does it exist simulation software which could work on small schematics like this one?
I must apply the power to the MCU with a delay, nothing else will exist to toggle a...
Thank you srizbf for looking,
10-12 seconds is fine, and I could always adjust the 33uf and 660K to adjust it.
I have no idea how to simulate it or even know what the final voltage output would be, i was thinking a few mV less than the supply,
Wanted to run it past some more knowledgeable...
Hi Guys and Gals,
I am just trying to create a bit of a power on delay for a small processor and wonder if this design is ok, I am a total nerd with this analog stuff and need like 2-5 seconds delay.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.