Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Orginally it was design this way...() pls see attached pic....however now i want to change to be have the cap sitting on the PCB board as i need to fab the hardware
I've redesign it however did not get the results i previous got..not even close...so i'm guessing i draw wrongly..
Hi all,
i sweeping my lump port cap in my antenna design..however i got different results each time i sweep.. any one can explain the use of parametric in hfss?
Here's my setup,
parametric setup -> linear step--
start = 1pF
Stop = 5pF
Step = 0.1pF
The S11 plot is diff from this setup
start...
yes..i can find them under the help guide..however i've tried it before..there's a error msg.."Body could not be created for part because of invaild parameters to CreateHelix operation"
i want to draw 5mm diameter,1mm pitch and 4 turns
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
