Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
I am going to use Bluetooth MAP and LAP profile in my application.
Can i know Bluetooth module that supports those profiles?
Thanks in advance....
Arul
Hi,
I am going to develop software for card emulation mode in PN512.
Can anyone provide sample source code for reference.
I found that ST21NFCA provides solution to card emulation mode.
But the firmware is not available.
Thanks to all..............
Hi all,
I am going to implement card emulation mode using PN512.
NXP documents and source code (BFL )are not sufficient to implement this functionality.
Can anyone provide documents and source code.
Thanks
Hi.......
I am implementing USB mass storage implementation on STM32.
I have used on chip flash memory as mass storage.
when i plug the device..it is detected by PC(windows)...
but is not formatted...i have only 256KB flash memory..which file system to be used for this small volume....
I am new to the ATZB-24-A2...zigbit module....i want to know the programming of the module....how to program.....what is the IDE?.....is there any software codes examples available...kindly reply to me.....
Thanks........
I am going to use ATZB-24-A2 for my project.I want to know the programmer and IDE for this chip......anyone can help me....I have ULINK2 and HJTAG...can i use above for programming the chip......pls give suggestion for me....
Thanks.....
Hi,
I am working on VL-FS-COG-BCD-12864-XX LCD module. i made communication between LCD and AT91SAM7SE512.
As per the specification of the Module,require 24v to drive the display panel.
I have tried with 2.2uf and 4.7uf as decoupling capacitor.but i can get driving voltage upto 17v.sometimes it...
Thank for your visit to my notification.
I want to know the connection diagram between micro controller (ARM) with spi interface and spi lcd using MISO and MOSI
I need detailed explanation about functions of each pins and command set of 128X64 spi LCD.
Added after 2 hours 15 minutes:
i...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.