Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have designed the voltage bosster and the input is 3 to 3.7v and i got the output as 6 and above but when i connect to the load that is my mobile its lagging and not getting charged kindly help me to fix here i have enclosed my circuit below
Hi i am designing a universal powerbank I get 5.18V output with 1A current but even though my mobile is not getting charged because in USB there are other two pins D+ and D- how to connect them to make all mobile to get charged in average time.please help me very much stucked
I am designing a smartphone powerbank using ic 7805 everything is ok,But my device is showing charging but its not getting charged and later i had heared about D+ and D- pin also should connected logically to get smartphone charge but each mobile companies have diffrent logic how to fix it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.