Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i am from pakistan what is efy you can email the link to it basically i have a working timer with all the features i mentioned above i want a code for it which suits the circuit i have the hardware and its working
Timer 0 is used for 1 second timer delay. Code is written for a hardcode 10 minutes timer. plus this code referred code is for three seven segment display i only have two displays and referred project has only two buttons but i want one with four button and not to forget the three codes
can...
can any one give me a code (asm or c) for a project that have
two 7segment display
four button control (up down mode and set)
have three modes
1-count down in hours(0-99hrs)
2-count down in minutes(0-99mins)
3-count down in seconds(0-99secs)
i will use this code in 89c2051 and 89c4051
can...
can any one of you give me your gmail email id or facebook id where i can chat with you please this is my first project and i am a begginer please help me
should there be semicolons before the line as follows??? look at the bold lines please
;
;
; FILE NAME 4Bit5000.ASM
;
; Project: DALLAS DS5000T MICRO Clock/Callendar
; Programmable Event Timer
; 11.0592...
i have bought the dallas chip and tried making the circuit but it does not worksi am posting more info about the project below please help me
i dont under stand is this information enough for the working of the circuit or do i need some thing else
can i post here the link to site from which i...
ok i didnot write the code and other things are in side attached file
it is not working means the circuit is not working with this code programmed in ds5000t micro controller
dear all i have made a programmable relay controller with alarm but i am having some problems with the display. it is not showing anything except the blinking cursor which means my crystal is working fine but except that i have no other display i need some expert help as i am only a beginer
dear all i have a really big asm code and the problem is it is not working is there any one who is really good at assembler codes who can check it ?? please reply
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
