Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
we successfully create a small pcb of size 20*40mm in orcad layout,,but for assembling in pick and place machine we need the pcb size of minimum 500*500 MM ,so we want to panelize the pcb and generate a pick and place report.
please help us with this
Thanks in advance
Hi all,
we are trying to make device which is used to measure some parameters and will plot it on the PC.The device used to transfer the data through wifi. Their are 5-10 device wants to establish the connection to the PC.The data rate is about 1Mbps for each device.
Is it possible to use a...
Hi,
we are trying to implement a low power soil moisture measurement unit.Any specialized ics are available for capacitive type soil measurement with high accuracy.
Thanks in advance.
Hi,
Thanks for replaying.
What we are trying is that we want to establish a bidirectional audio channel to a device and an android phone.Also we have some information regarding the condition in the room like lights intensity, temp, etc wants to monitor in the android device.
phone to device...
Hi,
we have a requirement of bidirectional audio transfer upto the range of 30 Meters. we add some decimal data with the audio data (not Continuous)
Please help to find an Ic suitable to our requirement.
Thanks in advance.
am using a SAMSUNG wireless charger (Model: EP: PG9201) Transmitter for my project, and at the receiver end I have RX coil of 26uH inductance and 520 mOhm DC Resistance, when i place the reciver assembly on top of the transmitter the coil is picking up voltage and pinging is taking place but it...
Hi,
I am working on a custom SIM800 board and the circuit is attached along with this. I've tested the circuit here and was working fine. My application uses HTTP get method to send the sensor data to a web server. When I installed the device in field which is actually inside a metal cabin it...
Hi All,
I have seen some active sensors are powered using current and voltage sources.and the output is measured using the ADC"s in the microcontroller, so my doubts is why some peoples are using the current source to drive the sensosr and then convert to voltage source using the current to...
Hi,
Noise has reduced to a greater extent. I could measure the RMS value with our laboratory setup. I assume there will be much more noise when it is installed in the field. So I should eliminate as much noise I can with this. How to select C1 and C7 values to further reduce noise? Shall I use...
Yes. This is what we want. It is going to be used in a high noise scenario, like old inverters. What I am asking is the capacitor C7 is creating noise in the circuit. Is it recommended to remove that capacitor? everything else is working fine.
thanks
Hi,
I am trying to measure AC rms voltage using PIC microcontroller. I have attached the circuit for measurement. I am connecting a 3V step down transformer out to the input of the circuit.The feedback capacitor has been added to reduce the noise, but I am getting noise if I add this. This is...
Hi all,
we want to solder OESIP based ic (MAX30100).we are tried three times manually but it fails.Any idea to solder how it?
Please help to solder this component.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
