Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I want electronic reversal of terminals of connector.
Can anyone give suggestion ?
The diagram is shown in the circuit.
I want terminals T1 and T2 to be connected between VCC and Ground or Ground and VCC by controlling Transistors Q1,Q2,Q3 and Q4.
My Vcc is square wave and it is varying...
Hi,
I am hardware design Engineer working on many areas like Board Design, PCB Design, Testing ect. In the course of time, I haven't done any SI analysis on my own. I know many concepts ect about Signal Integrity.
Now I want to know how to use tool (Preferably Cadence allegro) for SI analysis...
Hi ,
I have created the gerber drill file and the same attached here. (In Allgro)
I have some confusion how to interpret the data from drill file.
The Tool "T01" is used for total 118 drills. But total number of line items in drill file shown are 111. What happened to remaining 7 drills ?
Is...
Dear All,
I have one requirement for converting SDR Interface to DDR interface.
I am using one processor which is having SDR SDRM interface. Now, I want to convert that memory interface to DDR/DDR2. Is there any way to convert memory interface to DDR keeping the same processor ?
Thank you...
Hi All,
I want build a system of USB to RJ11 converter. It converts the data of USB type to PSTN data.
Does anyone have the documents,literature so that it will be helpful in designing.
Regards,
APSTNDP.
Hi all,
I am using 4 contact audio head phone jack in the design. I am not finding the documents which explain about the mic, head phone connections for headphone plug.
Can any one give me the pin connections of SAMSUNG and RELIANCE 4 contact headphone plug details ?
Can any one post those...
Hi All,
Does anyone have 8 bit Logic analyzer reference circuit ?
Can you give standard requirements of Logic analyzer ?
can you share literature for Logic analyzer implementation .
Re: JTAG software
Hi,
Using JTAG , I did flashing into boot flash. System is not booting up. I have doubt in memory interface. I want to write something into RAM using JTAG and verify that what ever is written so that I can find errors in RAM interface such as shorts, open etc.
Can any one...
JTAG software
Hi,
Can any tell which is free software available to write into RAM of XSCALE270 using JTAG unsing parallel port ?
Thanx in advance,
APSTNDP.
Hi All,
I have designed a board with PXA270 processor with boot flash, SDRAM and other chips. Once power is up, I could flash uboot using JTAG into boot flash.
After that when I restarted my system, my system is not booting up. I have flashed uboot couple of times, then also the same result...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.