Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: need embedded c code for adc7135 interfacing with N79E352 microcontroller
Then about which logic you are talking about....That AND logic is under the title BUSY...I am also referring Intersil ICL7135 datasheet...
Re: need embedded c code for adc7135 interfacing with N79E352 microcontroller
i applied same logic as given in datasheet i.e. anding busy and clock...then substracting 10001 from that count...but i am getting spikes only...i used T0 as timer and T2 to produce 125KHz...
and i am not expecting...
I am using clock,busy,run/hold and polarity pins of adc for interfacing with microcontroller.i am facing difficulty in reading counts of loadcell which is connected to adc.here are connections
busy-INT0,clock-T0 & T2,run/hold-wr,polarity-rd
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
