Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Multi meter
Capacitors require good and solid connections for a proper measurement. Use crocodile clips and wait for the result; it might take a minute to measure high value electrolytes. Check the meter manual for maximum possible value or you might have to wait forever! :D
longwire thickness
Have you measured the voltagedrop on the primary as well as on the secondary side of the supply’s? And if so; on which side does it drop?
A circuit diagram would help.
Re: Lead acid battery = 10V
If possible measure the specific gravity of the electrolyte in all cells, should be about the same in all cells (1.27 – 1.28). Check if you have any current “leaks” by disconnecting the negative wire from the battery (everything shut off in the vehicle) and connect a...
vibration sensors working principle in hindi
A piezo speaker is a good vibration sensor; it puts out a small signal from any shock or vibration. Try it!
how does a lm723 work?
For a 40 Volt output as standard the regulator is probably an L146 (or RU sim) which is similar to the LM723 but for a higher input voltage. The LM723 has a maximum input voltage of 40V and the L146 has 60 or 80V. The pin functions are the same so you can work around the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
