Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Marce
Could yo please help me out how to do SI in the Cadstar, I have only experience in the PCB layout and never done the SI practically , Though i know the basic concept and the high speeds guidelines regarding Ringing , Crostalk,Impedance and layer stack up I...
Hi Marce
CADIF is not the supported by hyperlynx , actually i am trying the self teach chapter of the Cadstar8.0 and after doing the scenario editor when select the topologies it works fine , but when do the simulation it again shows the above mentioned error...
Hi Marce
I have query that i have cadstar8.0 and can i do the Post SI in hyperlynx6.0? If so can you please tell me the process.
Regard's
Antarveena
---------- Post added at 08:10 ---------- Previous post was at 07:50 ----------
I mean how to transfer .pcb file to...
when i creating daisy chain model in the scenario editor and simulating the
model then rather then ,opening simulating window its showing such error.
Regard's
Antarveena
Is there any one who has used Signal integrity in CADSTAR?
As i am facing problem in doing simulation an error
as follows
@Simulation returned a fail with C:/ program / zuken
Regard's
Antarveena
Thanks for such quick response can you please tell me where to set spacing in the editor or in the XR. It would be help full if you provide me the steps
Regard's
Antarveena
hi all
i am facing one more error that while running the Batch Process for generating the Gerber . The color file can not be restored for e. g. like if i want to have Gerber of layer 2 , it shows in the layer 1 Gerber of only the default layer like ...
Hi All
I am facing problem that while importing its showing error as follows
Warning: Condition (r >= r) Not Satisfied
Invalid Required Entity detected
Path - (CADSTARPCB ([1]ASSIGNMENTS ([1]CODEDEFS ([173]SPCCLASSSPACE [3]-2147483647 ))))
Error: File content not consistent...
Re: How to change schematic files order in orcad project man
hi
Just Right Click on the schematic Page and go to Rename page and change the Page name
Regards
Antarveena
hi Dehati
I want to know the practical solution many people suggest many books if u have gone through the e books give me the answer buddy
:)
Regards
Antarveena
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.