Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear All
Thanks everyone for their valuable suggestions. My project is complete now and is working fine. I would like to take this opportunity to thanks each and everyone who helped me with this project on this forum.
And last but not the least, a special thanks to the big man "PETER". He...
I have tried to use that pot and tried to calibrate it for maximum range and still the maximum distance which I am able to cover is about 10 cm only, and yes I measured current with ampmeter and its about 286 mA.
Regards
It is an assembly of 5 Ir transmitters and receiver pairs arranged in a 2D array. Each pair works as a seperate IR sensor module. It is bascally used in path tracking robots. I am using two pairs out of 5. This module is available in market from various companies such as robokits or thinklabs...
Hey Peter... I have developed my project but now I am facing a problem of range... IR sensors are giving a very short range of around 5 mm only. Can you suggest some ideas to improve it upto at least 1 metre.
Regards
i have started designing my circuit but i am not able to get my hand on certain components such as relay and contactor and also i am facing some problems in programming
Please specify which one is electrolytic and which is ceremic
- - - Updated - - -
I have 10 uF electrolytic and 100uF ceremic and I dont have 100nF capacitor and yes I do intend to drive LCD,
I am using the 7805 but I am not getting the output. I connected the output (live) of the adapter to the input of 7805 and ground of adapter to the ground terminal of 7805 but I am getting nothing at the output terminal. Maybe its because too much current. output current of Adapter is 1 amp.
I have an adapter which is giving 12 V DC at no load, Can I use it for powering microcontrollers, (I guess no). So now I want to convert its output into 5 V Dc , Please suggest me the circuit diagram.
see I am not that much familiarwith coding or you can say that I am a novice. I assigned x just for comparison purpose, I found it more easier. Yes i accept that as I am not using the whole ports A and B so What can I do is just assign the particular pins if it can be done. Please let me know...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
