Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
autoroute in orcad
Have you tried looking up the Help documents of OrCAD for this error?
As always, manual routing is always better than auto routing, especially for critical nets.
copper pour pcb
I use Cadence Allegro PCB Editor and have found that it is best to do copper pouring towards the end of the layout.
Ususally GND or critical power nets are poured.
If using Cadence, it is difficult to edit or create new routes over existing copper pour areas. Hence it is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
