Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I try to build my simple Arduino based buck boost convertor . to do this I draw a basic schematic diagram In proteus 8.6 and try to run in simulation mode. but whenever I run with schottkey diode it thrown an error " no model specified for D1 , partition error". without D1 simulation works. I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.