Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
how convert very high frequency like 10Mhz to say 10Khz for an ac no change in any other parameters
easiest and cheapest...all methods
also is it possible just to use a LPF.
i want to convert a signal from crystal oscillator to low frequency say 10Khz frequency
sorry bad typo....i corrected the code i did copy paste sorry...the program is dumped to fpga kit an with dac and CRO gives output ....the second code i declared inout but first i didnt....is both program correct
thanks for reply
i am doing my 2nd year graduation of electronics and communcation..
i have only basic knowledge...it is NEGATIVE RAMP WAVE GENERATOR sorry i wasnt specific i will post the code below
.
RAMP
my code in exam (i didnt get any output in exam in CRO )
library IEEE;
use IEEE.STD_LOGIC_1164.ALL...
can i use signal and do operation and assign signal to port declared as out.rather than using it as inout and use directly whats the difference? Suppose the program is for negative ramp if i use output 12 bit as inout i can do d<=d-1 but if i use d as out and use another signal to do ds<=ds-1...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.