Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
latitude d630 windows xp cd boot
Hi,
This problem is due to the fact thant XP cannot identfiy SATA hardsiks without a driver.
the solution is :
go to the setup(BIOS) you will find something related to the hardisk controller called AHCI or something like that, change it to IDE after that...
I think you should repare your windows,if you are using windows XP go through the same steps as if you were going to install windows and instead of choosing setup choose repair,note:(don't select the option that says using recovery console, but proceed to setup and you will find a repair option...
there are many topics on the internet adressing the issue of Linux, google for "Setup is inspecting your computer’s hardware configuration" you will find topic on that issue.
if you were installing Linux you may have boot sector information left over from your Linux . if this is your case, you have to delete the active partitions and make a new ones
hi,
i'm using opamp 741 IC , as an inverting amplifier with gain equals 10, but i get very large out put about 11 volts when the input is in millivolts or with zero input,
i need help unrgently please , my circiut is attached.
hi all,
i'm a begginer
i tried to connect anADC0804 in the free running mode, but the out put is stable at a constant value or oscillating rapidly and it does no respond to the input.
i used the schematic in the datasheet .
please help me
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
