Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
IC gives active power, reactive power, V RMS, I RMS. Now I want to calculate POWER Factor, load shift, and power form the values I am getting from ADE7878.
Other question is I am getting the values in the form of count, I want to covert in meaningful value. For that I have to do scaling. My...
I interface ADE7878 with PIC.(SPI interface). I am able to interface properly and I am get the reading from following register of ADE7878
rms voltage & current
instantaneous voltage & current
reactive power
apperant power
active power
how should I calculate the
POWER
POWER FACTOR
LOAD SHIFT...
Reply with quote Edit/Delete this post Delete this post
Report this post to the moderators of this forum
hi
i am using ARM LPC2100 board of zlgmcu I will not able to execute the code for ADC and uart ADC i/p is connected to pin P0.28 and P0.27
I am using Cygwin as a compiler
Did you know any...
+freertos +lpc2114
hi
i am using ARM LPC2100 board of zlgmcu I will not able to execute the code for ADC and uart ADC i/p is connected to pin P0.28 and P0.27
I am using Cygwin as a compiler
Did you know any free software
I have a JTAG but i dont know , how to used with the board , for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
