Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by amirbaragh

  1. A

    How to measure the peak of a rectified pulse without sample and hold?

    i know ADC is suitable,but here the trigger of my pulses are not the same because of wide input frequency range that is 600MHz to 15GHz.also note that the duty cycle of RF input is very small. i give the RF signal to the input of the IC(LTC5564) and at the output i have a pulse.i want to...
  2. A

    How to measure the peak of a rectified pulse without sample and hold?

    Re: pulse peak measurement any help?! indeed i need a technique to measure the peak of a pulse with mentioned property!
  3. A

    how to measure the rise/fall time for a diode?

    no if it was in datasheet i would find it.i need an equation between junction capacitance and tr.model of the diode is SMS7630-061.if you can say the order of tr considering the Cj is enough for me.
  4. A

    how to measure the rise/fall time for a diode?

    you are right.but here there are some problems. 1)i just have a datasheet.i dont have the diode. 2)this diode must work in rf frequency such as 10GHz. tanx!
  5. A

    how to measure the rise/fall time for a diode?

    Hi i want to measure the rise/fall time for a diode that is a zero bias schottky diode.the Low parasitic impedance is less than .05 pF.can anyone help me to measuring,please?
  6. A

    How to measure the peak of a rectified pulse without sample and hold?

    Re: pulse peak measurement Hi Its a good way that i have considered it as the final way.but now i have choosed the ic ltc5564 to rectify my input and want to measure the peak of the output.note that my input is a pulse modulated signal.
  7. A

    How to measure the peak of a rectified pulse without sample and hold?

    Hi i want to measure the peak of a rectified pulse signal.one simple way is to use sample and hold.but here i have a signal in x band(high frequency) with duty cycle about 10ns.so i cant use sample and hold.please help me!

Part and Inventory Search

Back
Top