Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
We can use add trace and select the desired polygon to give width, material , thickness etc.
BTW thanks.
----------- updated -------------
yes i wanted to draw a triangle in CST Studio. Three lines(polylines) will form a triangle. then i want to assign those lines some material, thickness and...
I am designing a bow-tie antenna. I need to draw a triangle using polygon. but i want to cover lines that lines or triangle with some material, thickness, width. How can we do that in CST Microwave Studio 2011?
I am designing a bow-tie RFID tag antenna.I want to use chip (IC). As the impedance of chip is in complex form i.e 12-151j but when i use this impedance while assigning ports. it gives error.It works only on real values i.e 50 ohm, 70 ohm etc. how to give complex impedance in CST???
I want to use human model in CST microwave studio 2011.
I have found a model voxel file working at 2.4 Ghz, but its material and properties file cannot be edited. I want the model to run at 860-960 Mhz range. Need help. If any one know the solution
or if any one has model running at that range??
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
