Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I was working on MATLAB and i don't think it would be able to handle this much of data. As said above, people are working with moderate data. My code works with small data rates but same thing gets stuck when using large data.
I am writing my dissertation for my final year project. In the Introduction part my guide has asked me to put up a section about printed antennas. I searched the topic on net. But no where could find anything concrete. Can you guys help me out with the contents which i should put in this section.
I have been alloted a project on Automatic Face Recognition of a film character using MATLAB as a part of my curriculum. I don't know from where to start. Can someone help me out ?????
@ Zeeshan: I have already done size minimization. bandwidth enhancement. Dual band patches, microstrip patch array. I already did gain enhancement using photonic substrates. I would look into your suggetion of RFID. I have never touched it. I would be thankful if u could give me more specific...
Final Year Project
I wish to do my final year project in RF/Microwaves/Antenna Designing. I would like you guys to suggest some good topics for tht.
Thanks..........
I am working on a modified horn which has a ridge and a launching plane inside. In the design i need to connect the launching plane to the ground plane using a 100 ohm resistor. The problem is i don't know how to get resistors into Fidelity or IE3D. Please help.
Meander Patch Antenna
I was working on a science Direct paper in which i have to design a meander patch antenna and use a quarter wave transformer between the feed and the patch. How do i design it in IE3D. Please help..............
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.