Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
well guys i find the atmega welder really complex. the link which i have given is a very simple welder based on uc3844 it has current feedback and again here they are ( for those who havent noticed it). :
Welding inverter 100A ------ this link is original and shows voltage and...
there are topologies for switched power supplies and there is one for a welding inverter ill try to find out and post it as quickly as possible
---------- Post added at 20:46 ---------- Previous post was at 20:45 ----------
finally i found a schematic and the topology used in the welding...
to build a welder u could use PULSE WIDTH MODULATION circuit to control a mosfet which switches a step down transformer on and off
---------- Post added at 20:27 ---------- Previous post was at 20:23 ----------
if the inverter circuit is difficult to find then one must go with a MOT WELDER.
IT...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.