Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
So the trace for the red circle point is the orange circle point, however this has lifted off the board.
The point that is connected to the next point to the orange circle point however has continuity. Could I therefore solder a wire to this point and bridge it across to the battery?
Hi All,
I urgently require help and was wondering if I can kindly get some advice on the below.
So I have a remote car key PCB here that is usually fitted with a button type rechargeable battery that is soldered on.
The key remote doesn't work and upon opening the casing it is apparent that...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.